Angle - Revision history

Fabcam1 at 21:57, 6 June 2014

2014-06-06T21:57:47Z

Fabcam1 at 21:57, 6 June 2014

2014-06-06T21:57:24Z

Fabcam1: Created page with "'''Bend-Tech 7x Wiki :: Assembly :: PickPoints :: Angle''' NOTOC right

Angle

Creates a PickPoint that is at a..."

2014-06-06T20:49:52Z

Created page with "'''Bend-Tech 7x Wiki :: Assembly :: PickPoints :: Angle''' __NOTOC__ right <h3>Angle</h3> Creates a PickPoint that is at a..."

New page

'''[[Main Page|Bend-Tech 7x Wiki]] :: [[Assembly]] :: [[PickPoints]] :: Angle'''
__NOTOC__ [[File:pickpoints_angle.png|right]]

<h3>Angle</h3>
Creates a PickPoint that is at a specified angle and distance from another PickPoint.

Click the '''Set Reference''' button and click on a PickPoint to set it as the reference point.

Use the Tri-Globe to select the direction of the new point. Enter an angle, using the Tri-Globe to determine which direction 0° and 90° are. Enter the distance from the reference point that the new point should be in the Length field.

Click the '''Apply''' button to place the PickPoint.

Alternatively, you can leave the Length and Angle field at 0 and use the two fields below the Length field to enter the distance from the reference point.

← Older revision		Revision as of 21:57, 6 June 2014
Line 13:		Line 13:
	Alternatively, you can leave the Length and Angle field at 0 and use the two fields below the Length field to enter the distance from the reference point.		Alternatively, you can leave the Length and Angle field at 0 and use the two fields below the Length field to enter the distance from the reference point.

−	'''Note:''' For easier navigation, notice how the ~~harpoon fields axis~~ rotates with the display frame and matches the orientation of the parts/points.	+	'''Note:''' For easier navigation, notice how the tri-globe rotates with the display frame and matches the orientation of the parts/points.

← Older revision		Revision as of 21:57, 6 June 2014
Line 12:		Line 12:

	Alternatively, you can leave the Length and Angle field at 0 and use the two fields below the Length field to enter the distance from the reference point.		Alternatively, you can leave the Length and Angle field at 0 and use the two fields below the Length field to enter the distance from the reference point.
		+
		+	'''Note:''' For easier navigation, notice how the harpoon fields axis rotates with the display frame and matches the orientation of the parts/points.

Angle - Revision history

Fabcam1 at 21:57, 6 June 2014

Fabcam1 at 21:57, 6 June 2014

Fabcam1: Created page with "'''Bend-Tech 7x Wiki :: Assembly :: PickPoints :: Angle''' __NOTOC__ right

Angle

Fabcam1: Created page with "'''Bend-Tech 7x Wiki :: Assembly :: PickPoints :: Angle''' NOTOC right