Fabcam1 at 15:51, 12 June 2014

2014-06-12T15:51:05Z

Fabcam1: Created page with "'''Bend-Tech 7x Wiki :: Header Design :: Explode''' NOTOC right In the Explode tab, tubes can be exploded/broken apart to s..."

2014-06-12T14:19:28Z

Created page with "'''Bend-Tech 7x Wiki :: Header Design :: Explode''' __NOTOC__ right In the Explode tab, tubes can be exploded/broken apart to s..."

New page

'''[[Main Page|Bend-Tech 7x Wiki]] :: [[Header Design]] :: Explode'''
__NOTOC__ [[File:header_explode.png|right]]

In the Explode tab, tubes can be exploded/broken apart to show each section (See the diagram below for an example of this). While 'All Tubes' is selected in the Tube List, all of the header tubes will be shown while using the Explode function. Otherwise, whichever tube is selected/highlighted will be the only tube shown.

[[File:header_explode_1.png|250px]]

Click the '''No J-Bends (Complete Explode)''' option to have the part completely exploded into arcs and straight sections.

Click the '''Start on Header Side''' option to have the part exploded into straight sections and J-bends with the short end starting at the header end of the tube.

Click the circle next to '''Start on Collector Side''' to have the part explode into straight sections and J-Bends with the short end starting at the collector end of the tube.

Check the box next to '''Allow J-Bend to flip if zero tail length''' to let J-Bends automatically flip which direction they face if necessary.

Enter how much distance to have between each separate section in the field next to '''Explode Amount'''.

Click the '''Apply to All Tubes''' button [[File:apply_alltubes.png]] to have all the chosen settings applied to all of the header tubes in the list.

Click '''Save Orientation''' to have the current view (rotation/move) of the part(s) saved. Once saved, any time the Explode tab is accessed while in same session and part file, the view will be set back to the chosen orientation.

← Older revision		Revision as of 15:51, 12 June 2014
Line 3:		Line 3:


−	In the Explode tab, tubes can be exploded/broken apart to show each section (See the diagram below for an example of this)~~. While 'All Tubes' is selected in the Tube List, all of the header tubes will be shown while using the Explode function. Otherwise, whichever tube is selected/highlighted will be the only tube shown~~.	+	In the Explode tab, tubes can be exploded/broken apart to show each section (See the diagram below for an example of this).

		+	While '''All Tubes''' is selected in the [[Header Design#Header Chart\|Header Chart]], all of the header tubes will be shown while using the Explode function. Otherwise, whichever tube is selected (highlighted in yellow in the chart) will be the only tube shown.

−	[[File:~~header_explode_1~~.png\|~~250px~~]]	+
		+	[[File:header_explode_2.png\|600px]]

Header - Explode - Revision history

Fabcam1 at 15:51, 12 June 2014

Fabcam1: Created page with "'''Bend-Tech 7x Wiki :: Header Design :: Explode''' __NOTOC__ right In the Explode tab, tubes can be exploded/broken apart to s..."

Fabcam1: Created page with "'''Bend-Tech 7x Wiki :: Header Design :: Explode''' NOTOC right In the Explode tab, tubes can be exploded/broken apart to s..."