Fabcam1 at 20:54, 11 June 2014

2014-06-11T20:54:02Z

Fabcam1: Created page with "'''Bend-Tech 7x Wiki :: Header Design :: Edit :: Move''' right

Move Features

Click the '''Move Part''' button [[File:m..."

2014-06-11T20:52:54Z

Created page with "'''Bend-Tech 7x Wiki :: Header Design :: Edit :: Move''' right <h3>Move Features</h3> Click the '''Move Part''' button [[File:m..."

New page

'''[[Main Page|Bend-Tech 7x Wiki]] :: [[Header Design]] :: [[Edit]] :: Move'''
[[File:header_edit.png|right]]
<h3>Move Features</h3>

Click the '''Move Part''' button [[File:move_part.png]] to move full parts to new locations.

First, click on a PickPoint of a part. If Incremental Move is not checked, you will be asked to choose which PickPoint will be the anchor point. You will then be able to click any PickPoint to place the part there, with its anchor point centered on the point you select. If '''Incremental Move''' is checked, you will only have to click the part you are moving once. You will then be able to enter values into the Front, Back, Left, Right, Ceiling, and Floor fields in order to move the part in that direction by that value. To reset all fields to 0, click the Clear Values button.

To finalize and move the part to the new location, click the '''Apply''' button.

Click the '''Move Feature''' button [[File:move_feature.png]] to move single features.

First, click a part and select a feature to move. If Incremental Move is checked, enter values into the Front, Back, Left, Right, Ceiling, and Floor fields and click the Apply button. If Incremental Move is not checked, click a PickPoint to move the feature there. The part will then be adjusted accordingly. See image below for an example of this function.

[[File:header_movefeature.png|1000px]]

<h3>Move Bend</h3>

Click the '''Nudge Bend''' button [[File:nudge_bend.png]] to push a bend a given amount in a specific direction.

Next, select the bend that will be adjusted. Use the green and pink directional buttons to slightly push the bend in a certain direction. The amount that the bend will be nudged is determined by the value in the '''Amount''' field, which can be adjusted by supplying a new amount.

Click the '''Use Mouse''' button [[File:use_mouse.png]] to move a bend using the mouse controls.

First, select the bend to move. Next, the move bend tool will be placed upon this bend and can be used by clicking and dragging any of the arrows to pull the bend in a certain direction.

[[File:header_movebend.png|1000px]]

@@ Line 1: / Line 1: @@
-'''[[Main Page|Bend-Tech 7x Wiki]] :: [[Header Design]] :: [[Edit]] :: Move'''
+'''[[Main Page|Bend-Tech 7x Wiki]] :: [[Header Design]] :: [[Header - Edit|Edit]] :: Move'''
 [[File:header_edit.png|right]]
 <h3>Move Features</h3>

Header - Move - Revision history

Fabcam1 at 20:54, 11 June 2014

Fabcam1: Created page with "'''Bend-Tech 7x Wiki :: Header Design :: Edit :: Move''' right

Move Features