Fabcam1 at 15:22, 9 June 2014

2014-06-09T15:22:36Z

Fabcam1: Created page with "'''Bend-Tech 7x Wiki :: Assembly :: Design :: LRA''' NOTOC right"

2014-06-06T21:50:33Z

Created page with "'''Bend-Tech 7x Wiki :: Assembly :: Design :: LRA''' __NOTOC__ right"

New page

'''[[Main Page|Bend-Tech 7x Wiki]] :: [[Assembly]] :: [[Design]] :: LRA'''
__NOTOC__ [[File:design_lra.png|right]]

← Older revision		Revision as of 15:22, 9 June 2014
Line 1:		Line 1:
	'''[[Main Page\|Bend-Tech 7x Wiki]] :: [[Assembly]] :: [[Design]] :: LRA'''		'''[[Main Page\|Bend-Tech 7x Wiki]] :: [[Assembly]] :: [[Design]] :: LRA'''
	__NOTOC__ [[File:design_lra.png\|right]]		__NOTOC__ [[File:design_lra.png\|right]]
		+
		+
		+	'''To begin designing a part''' using the LRA interface, click the '''New Part''' button. [[File:new_part.png]]
		+
		+
		+	Next, '''enter the number''' of bends the new part will have in the prompt that appears.
		+
		+	[[File:design_lra_1.png\|250px]]
		+
		+	Now the LRA design fields will be shown on the left side of the window.
		+
		+
		+	First, '''select the starting point''' of the point by clicking on a PickPoint in the display area.
		+
		+
		+	'''Enter the length, rotation, and angle values''' into the design fields to define the shape of the part. Once at least the first two rows in these fields are filled, a preview of the part will be shown in the display area. The part will be represented by a dark purple line and the current bend being designed will be highlighted in red.
		+
		+	'''The direction of the part''' can be adjusted by choosing a first and second direction point. See the example below.
		+
		+	[[File:design_lra_2.png\|1000px]]
		+
		+
		+
		+	Each bend will have the option to choose a die and a dimension type. To choose a die, click the '''Die''' drop down menu and select an option from the list. To choose a dimension type, click the '''Dim Type''', and select Apex, Tangent, or Perp from the list.
		+
		+	Apex will measure to the outside intersection (apex) of the bends two legs. Tangent will measure to the edge of the bends, the tangents, so no bent material will be included in the measurements. (See images below) Perp is basically the tangent plus the CLR of the bend.
		+
		+	:::[[File:apex.png\|200px]] [[File:tangent.png\|186px]]
		+
		+
		+	'''To add points''', click the '''Create Points''' button [[File:create_points.png]] to place points along the current part. '''Note:''' This will ''only'' place points, the actual part will not be created.
		+
		+	'''To complete the part''', click the '''Apply''' button. [[File:apply_part.png]]

LRA - Revision history

Fabcam1 at 15:22, 9 June 2014

Fabcam1: Created page with "'''Bend-Tech 7x Wiki :: Assembly :: Design :: LRA''' __NOTOC__ right"

Fabcam1: Created page with "'''Bend-Tech 7x Wiki :: Assembly :: Design :: LRA''' NOTOC right"