Dragon Straight Part Tutorial

From Bend-Tech 7x Wiki
Revision as of 15:26, 18 January 2016 by Fabcam1 (talk | contribs)
Jump to: navigation, search
Dragon Straight Part Tutorial
Drag Straight1.png

Things To Know

  • This tutorial will step you through the process of creating a straight design in Bend-Tech Dragon and show you the possible choices for where to take it next depending on your needs. As you walk through this tutorial, procedures are designed based on your knowledge of earlier procedures. Because of this, it is very important that you carefully step through this guide, understanding everything along the way.

Tutorial

1. From the Bend-Tech Dragon start up screen, click on the Straight Dragon Straight Part(2).png button to open the straight part interface.

2. Now, maximize the screen Min Max Close Tab.png.

3. Next, select the Tube Length value field Tube Length1.png and enter the number 24. The straight tube should appear below in the display area.


Straight 24 In Tube.png

4. From here, check both Display Cross Tube Dragon Display Cross Tube1.png checkboxes on either side of the Tube Length value field.


Straight 24 Cross Tubes Attached.png

5. Now, type in 110 into both Angle Drag-Angles1.png value fields. This will adjust the angle of the copes as shown in the display area.


Straight 24 Angles Attached.png

6. Next, type 180 into the Rotation Drag Rotations1.png value field beneath the Tube Length field.


Straight 24 Rotations Attached.png