Dragon Straight Part Tutorial
Things To Know
- This tutorial will step you through the process of creating a straight design in Bend-Tech Dragon and show you the possible choices for where to take it next depending on your needs. As you walk through this tutorial, procedures are designed based on your knowledge of earlier procedures. Because of this, it is very important that you carefully step through this guide, understanding everything along the way.
Tutorial
1. From the Bend-Tech Dragon start up screen, click on the Straight .png)
button to open the straight part interface.
2. Now, maximize the screen 
.
3. Next, select the Tube Length value field 
and enter the number 24. The straight tube should appear below in the display area.
4. From here, check both Display Cross Tube 
checkboxes on either side of the Tube Length value field.
5. Now, type 110 into both Angle 
value fields. This will adjust the angle of the copes as shown in the display area.
6. Next, type 180 into the Rotation 
value field beneath the Tube Length field.
7. Now, type .875 into the Offset 
value field on the right hand side. This will cause the cross tube on the right side of the project to offset from the centerline by half the diameter of the tubing.
8. To finish this part, select the Miter 
option in the Type of Cut (Start) section and change the angle to 45 in the left Angle 
value field. The part should appear in the display screen as seen below.
Transferring
- After applying all of the changes to our straight part, we are free to select the desired option for transferring the part out.
- You may Transfer to Design
for adding further geometry to the part and assigning actions before sending it to the machine, or you may Transfer to Nesting 
if you'd like the current part to be added to a nesting project without altering the part further.
- See the Dragon guide to help you decide where to go from here.
