Dragon Bent Part Tutorial
Things To Know
- This tutorial will step you through the process of creating a bent part design in Bend-Tech Dragon and show you the possible choices for where to take it next depending on your needs. As you walk through this tutorial, procedures are designed based on your knowledge of earlier procedures. Because of this, it is very important that you carefully step through this guide, understanding everything along the way.
Tutorial
1. From the Bend-Tech Dragon start up screen, click on the Bent button to open the bent part interface.
3. Next, select 4 from the Number of Bends drop down menu to the far left.
4. Now, enter the values in the LRA value fields to the left of the display screen according to the picture shown below.5. Make sure to also enter 90 into the Start Angle value field. This will cause the design in the display screen to rotate 90 degrees and stand straight up.
6. Next, select the Cut Start tab from the upper left hand corner, select the Coping (Fishmouth) option and check the Display Cross Tube checkbox.
7. Then, enter 90 into the Rotation value field and 110 into the Angle value field.
8. Now, select the Cut End tab, select the Coping (Fishmouth) option again and check the Display Cross Tube checkbox.
9. Finally, enter 270 into the Rotation value field and 110 into the Angle value field.