Difference between revisions of "Dragon Bent Part Tutorial"

From Bend-Tech 7x Wiki
Jump to: navigation, search
Line 26: Line 26:
 
8. Now, select the '''Cut End''' [[File:Drag_Cut_End2.png]] tab, select the '''Coping (Fishmouth)''' [[File:Drag_Coping_Fishmouth.png]] option again and check the '''Display Cross Tube''' [[File:Dragon_Display_Cross_Tube1.png]] checkbox.
 
8. Now, select the '''Cut End''' [[File:Drag_Cut_End2.png]] tab, select the '''Coping (Fishmouth)''' [[File:Drag_Coping_Fishmouth.png]] option again and check the '''Display Cross Tube''' [[File:Dragon_Display_Cross_Tube1.png]] checkbox.
  
9. Finally, enter '''180''' into the '''Rotation''' [[File:Drag_Rotation_1801.png]] value field and '''110''' into the '''Angle''' [[File:Drag-Angles1.png]] value field.
+
9. Finally, enter '''270''' into the '''Rotation''' [[File:Drag_Rotation_2701.png]] value field and '''110''' into the '''Angle''' [[File:Drag-Angles1.png]] value field.
  
 
[[File:Drag_Bent_Cut_End1.png]]
 
[[File:Drag_Bent_Cut_End1.png]]

Revision as of 14:32, 19 January 2016

Dragon Bent Part Tutorial
Drag Bent1.png

Things To Know

  • This tutorial will step you through the process of creating a bent part design in Bend-Tech Dragon and show you the possible choices for where to take it next depending on your needs. As you walk through this tutorial, procedures are designed based on your knowledge of earlier procedures. Because of this, it is very important that you carefully step through this guide, understanding everything along the way.

Tutorial

1. From the Bend-Tech Dragon start up screen, click on the Bent Dragon Bent Part(1).png button to open the bent part interface.

2. Now, maximize the screen Min Max Close Tab.png.

3. Next, select 4 from the Number of Bends Drag 4 Number Of Bends1.png drop down menu to the far left.

4. Now, enter the values in the LRA value fields to the left of the display screen according to the picture shown below.
Drag Bent Hoop1.png

Drag Bent LRA Values1.png

5. Make sure to also enter 90 into the Start Angle Drag Start Angle 901.png value field. This will cause the design in the display screen to rotate 90 degrees and stand straight up.

6. Next, select the Cut Start Drag Cut Start2.png tab from the upper left hand corner, select the Coping (Fishmouth) Drag Coping Fishmouth.png option and check the Display Cross Tube Dragon Display Cross Tube1.png checkbox.

7. Then, enter 90 into the Rotation Drag Rotation 901.png value field and 110 into the Angle Drag-Angles1.png value field.

Drag Bent Cut Start1.png

8. Now, select the Cut End Drag Cut End2.png tab, select the Coping (Fishmouth) Drag Coping Fishmouth.png option again and check the Display Cross Tube Dragon Display Cross Tube1.png checkbox.

9. Finally, enter 270 into the Rotation Drag Rotation 2701.png value field and 110 into the Angle Drag-Angles1.png value field.

Drag Bent Cut End1.png