Dragon Bent Part Tutorial

From Bend-Tech 7x Wiki
Revision as of 13:11, 19 January 2016 by Fabcam1 (talk | contribs)
Jump to: navigation, search
Dragon Bent Part Tutorial
Drag Bent1.png

Things To Know

  • This tutorial will step you through the process of creating a bent part design in Bend-Tech Dragon and show you the possible choices for where to take it next depending on your needs. As you walk through this tutorial, procedures are designed based on your knowledge of earlier procedures. Because of this, it is very important that you carefully step through this guide, understanding everything along the way.

Tutorial

1. From the Bend-Tech Dragon start up screen, click on the Bent Dragon Bent Part(1).png button to open the bent part interface.

2. Now, maximize the screen Min Max Close Tab.png.

3. Next, select 4 from the Number of Bends Drag 4 Number Of Bends1.png drop down menu to the far left.

4. Now, enter the values in the LRA value fields to the left of the display screen according to the picture shown below.

Drag Bent LRA Values1.png

5. Make sure to also enter 90 into the Start Angle Drag Start Angle 901.png value field. This will cause the design in the display screen to rotate 90 degrees and stand straight up.