Values (Arc)
Revision as of 13:49, 6 June 2014 by Fabcam1 (talk | contribs) (Created page with "thumb|0° is to the right, rather than up. == Description == Creates an arc based on start angle, end angle, and radius. == How-To == Input the rad...")
File:CADdegrees.PNG
0° is to the right, rather than up.
Description
Creates an arc based on start angle, end angle, and radius.
How-To
Input the radius, start angle, and end angle of the arc into their respective fields. Click on a point to place the arc with its center directly over that point. Check the Full Circle checkbox to automatically set the start angle at 0 and the end angle at 360, creating a full circle.