Rotation

From Bend-Tech 7x Wiki
Revision as of 14:08, 5 June 2014 by Fabcam1 (talk | contribs)
Jump to: navigation, search

The rotation (as a default and without the LRA extension module for SE) is incremental between bends. So, once a bend is performed the rotation is considered to be 0 at that point in time and the rotation amount is based upon the amount of rotation between bends.

Rotation1.png

In the above picture notice how bend #4 has a rotation of 0. This shows no rotation between bends 3 and 4.

NOTE: If you need to have absolute rotation like that need when the material held in place by a chuck then the LRA extension module is needed.