Tube Skinning Process

From Bend-Tech 7x Wiki
Revision as of 14:19, 12 January 2018 by Fabcam1 (talk | contribs) (Created page with "'''Bend-Tech Tube Skinning Process:''' The development staff at Bend-Tech LLC uses the points below on a 3D tube to lay it out in an unwrapped, or skinned version shown in t...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Bend-Tech Tube Skinning Process:


The development staff at Bend-Tech LLC uses the points below on a 3D tube to lay it out in an unwrapped, or skinned version shown in the flat layout image below.


As you can see, the Top of the tube is the point where it's split, allowing for the top and bottom of the flat layout to share the same line (Top).

Tube Skinning.jpg

Retrieved from "http://www.bend-tech.net/wiki7/index.php?title=Tube_Skinning_Process&oldid=9575"